GENERAL INSTRUCTIONS (Please read the following instructions very carefully)
1. Question marks are mentioned with each Question.
2. Please write neat and clean hand-writing on Answer Sheet. Use Margin on right side and left side of Answer Sheet.
3. Do not refresh or back page.
4. Do not click the button Submit Test before completing the paper on Answer Sheet.
5. This is a ONE TIME attempt test. Once started, it cannot be reversed or attempted again.
6. Take photo of all the Sheets and make single pdf file.
1
Electric fuse is based on the principle of __________________
Magnetic effect of electric current
Chemical effect of electric current
Heating effect of electric current
B
oth heating and magnetic effect of electric current
2
Which of the following are correct :
(a) We should not try to repair appliances without a proper technical knowledge.
(b) We must ensure that MCB and fuses of correct strength have been used in the circuit.
Only (a) is correct.
Only (b) is correct.
Both (a) and (b) are correct.
None of these.
3
The necessary requirements for a fuse wire are ___________________
Conductor with low melting point
Conductor with high melting point
Insulator with low melting point
Insulator with high melting point
4
Which has no importance for fuse wire ________________.
Specific resistance of wire
Diameter of wire
Length of wire
Current passing through the wire
5
When a fuse is rated 8A, it means __________________
It will not work if current is less than 8A
It has a resistance of 8 ohm
It will work only if current is 8A
It will burn if current exceeds 8A
6
Electricity from power stations is transmitted to homes through __________________ voltage power lines.
High
Medium
Low
7
The + ve terminal of Ammeter is connected to ____________ terminal of the circuit and - ve terminal is connected to ____________ terminal of the circuit.
Higher potential, lower potential
Lower potential , Higher potential
Attached at same terminal
None of the above
8
The internal resistance of a voltmeter must be very high so that ____________________________ .
Minimum current passes through the meter
Range is high
Accuracy is high
Loading effect is maximum
9
An electric fuse work on ___________ effect of electric current .
Heating
Magnetic
Chemical
10
Wire connected to bypass a protective circuit is known as ______________
Contractor
Jumper
Fuse
MCB