GENERAL INSTRUCTIONS (Please read the following instructions very carefully)
1. Question marks are mentioned with each Question.
2. Please write neat and clean hand-writing on Answer Sheet. Use Margin on right side and left side of Answer Sheet.
3. Do not refresh or back page.
4. Do not click the button Submit Test before completing the paper on Answer Sheet.
5. This is a ONE TIME attempt test. Once started, it cannot be reversed or attempted again.
6. Take photo of all the Sheets and make single pdf file.
1
To construct an angle of 300 as shown in the diagram the first step is to :
With P as the center and without any change in the radius, draw an arc that cuts the semicircular arc at point R.
Draw a line segment OA
With P and R as the center, draw two arcs that intersect each other and label it as S.
None of the Above
2
To construct an angle of 300 , we construct the angle bisector of _____________
150
600
900
1200
3
A 900 angle is exactly half of a ________
Right angle
Obtuse angle
Straight angle
Acute angle
4
What type of angle is 30 degree?
Acute Angle
Right Angle
Obtuse Angle
All of the Above
5
Prependicular bisector of a line segment :
is parallel to it
divide it into two equal parts
make angle of 800 angle
None of these
6
Howe many arcs are drawn while constructing angle of 30 degree?
7
Perpendicular bisector of a chord of a circle is _____________.
does not passes through the centre
passes through the centre
Both A and B
8
Angle bisector of given angle can be constructed accurately using ________________.
Pair of compasses
Ruler
Set of Squares
Divider
9
If we bisect an angle of a rectangle , we get 2 angles each of ________
450
300
350
10
To construct an angle of 900 as shown below. Which of the statement below is incorrect
Draw a ray OA.
Draw OT and produce it to B.
With O as centre and any convenient radius, draw an arc, cutting OA at P.
11
How many arcs are drawn to construct an angle of 900 ?
12
Arrange the steps in correct order to make the construction in the diagram:-
1. With centre P and radius more than half of PQ, draw an arc in the interior of
2.Join OS and product it to any point C.
3. With centre R and the same radius, draw another arc intersecting the arc in step III at S.
4.Draw by using the steps mentioned above.
5.With centre O and any convenient radius draw an arc cutting OA and OB at P and R respectively.
1,4,2,3,5
1,2,3,5,4
1,2,4,3,5
4,5,1,3,2
13
How many arcs are required to be drawn to construct an angle of 600 ?
Three
Two
Four
One
14
Arrange the following steps in a sequence manner to construct an angle of :
Step 1. Take P as a center and with the radius of the same length mark an arc on the former arc at a point R.
Step 2. On a plane, sheet draw a line segment OA.
Step 3. Join points O to R and produce up to point B.
Step 4. Take O as a center, draw an arc with proper radius.
1,2,3,4
4,2,1,3
2,4,1,3
1,4,3,2
15
To draw an angle of as shown in the figure below, which of the following step is incorrect.
1. With R as centre , draw an arc with radius more than half of PR.
2. Join points O and C. OC is the bisector of
3. Draw an angle AOB = 60 degree.
4. With P as centre and same radius as in step 1 draw another arc that intersects the previous arc at point S.
Only 1 and 2
Only 2 and 3
Only 3 and 4